borked 480

[mk-ultra]

thanks for the inputs guys, it really helps

just to be sure
1:perfectly fine with vmem mod
2:added cap @ c1045 + vgpu/vmem read point
3:instabilty at known stable frequency
4:removing the cap by twsting it, power was off(hit the power button a few times),but the card was still in the mobo.
5:booting but for no more than 5-10min
6:removing everythings i've added @ 2 = no boot+cap fell off
7:in deep sh1t
8:crying alone in the dark

for some reasons i though it was a resistor LOL

just to be sure the cap i've added wasn't there, it's located at C1045 just like here. > http://pepinorang.jr.free.fr/screens...0/DSC02424.JPG.

i tried to run the card yesterday and no go, mobo gives a big beep at "2d" post code and stays there. before i removed everything and the cap fell off i was able to boot 1 in 5 times or so.


another thing, i tried to measure capacitance but my dmm only reads in "f" not in "uf", but i'm surprise it's a nice model, not a top of line fluke but i wasn't expecting that this one woul not do everything i needed. So now i guess i need a new dmm which doesn't suck and some old mobo vga to get a cap of the same value. But i'm not holding my breath for it to be working. By g.foyle post i seem to understand that i can't measure capacitance with cap solderer?

WeStSiDePLaYa
Yes i'm from quebec, you too?
i'm 99.9% positive it's not shorting right now, the pic sucks i know. But i was pretty sure it wasn't after soldering the vgpu read point either, so who knows.

ket don't put me down more than i am