I've been pretty much able to get my 1055T stable at 3850mhz. I'm just not sure if my temps are unusually high.

Running prime on small FFT I get the following temps at stock speed / stock voltage. Is TMPIN0 the temp of my cpu or is TMPIN1 or TMPIN2? Do these temps seem about right at stock speed/voltage? I'm using Cooler Master Hyper 212 Plus CPU Cooler. I installed w/ Artic Silver 5 compound, but had to twist the cooler after setting down b/c initially set down facing the wrong direction (oops). I didn't lift it off the cpu at all, i just twisted it to the correct position. I'm wondering if that could affect my installation. I also noticed there was a tiny section on the side of the cpu that wasn't fully covered by the heatsink, although I didn't see any other way that it would have locked in (I don't think I didn't anything wrong on that front).

Thanks in advance for any response / advice.