Xtreme Phase Change Insulation Guide

[Dumo]

My hardwares always change, but basic cooling still the same unmoded Mach II GT and Vapo LS. I use Mach II's back heater and seal string, Vapo's socket pad and Duniek's Evap mounting. No dielectric grease on the socket

Most of the time rig run avg. 15 hours daily w/out condensation problem in winter or summer (east coast)

Always important when turning on phase is to wait until evap temp. reached (almost) -25/30 C, so all moisture in around socket will freez...then boot up. Leaving the system idle @ stock speed for long period of time also a bad call, especially w/out heat pad