Asus Crosshair IV 0801 Bios

[Leeghoofd]

My Crosshair IV and 1055T combo are acting up...

I have the following settings applied:

In the first boot and ONLY in the first boot, after Windows pops up, it works for a while and then, inevitably after a few seconds or minutes i get a BSOD. I then shut down the power supply in the power button, let the motherboard "discharge" and power on the PSU once again. I press the power button and it boots happily to never crash again until i leave it off for a good 6-7 hours time.

If i turn the PC off and back on 3-4 hours later, this doesn't happen. It does happen if i turn it off now, go to bed and turn it back on - BSOD after windows loads as i described above.

The RAM i'm using is GSKILL Trident 2x2GB PC3-12800 8-8-8-24 at 1.60v.

Any ideas why this is happening?

Do me a favour and next time it crashes , reboot and go into the bios and read out the CPU NB voltage plz... if it's lower then the voltage you applied report back... though I must say 1.2CPU/NB voltage is already low... Try upping to 1.25-1.3ish

I made a small homevideo of my NB voltage issue I've been experiencing since 0707 bios... passed it on to the big shots at Asus...