H20 | AMD Phenom II C3 | Dragon's Revenge | Ultimate Thread

[charged3800z24]

As for the CPU Multipliers/FSB those are for you to set, not actuall readings so thats why if you look at the top it shows correct numbers. Mine does that too.

Must be the 890 boards then, my 790FX works perfect in AOD for voltage and frequency etc. I had made all those changes in the bios. When I do this on my 790FX board, the Target reads the same as my current. Just thought it was weird.

[charged3800z24]

Don't mean to double post, just wanted to share some test I did. Nothing as exciting as Oldtimer was doing, but here it is. I ran test in 3d06 to see the differences with memory allocation on the IGP. If you notice, there can be a 300 point gain from adding side port. Now I may need to run a no sideport with 128MB shared to see the speed difference in shared and sideport.

Ok, I added a no sideport but with 128MB shared. It is below. I am now intrigued to run this with 1333 MEM just to see... probably would make a huge difference, but look at how much faster the 128MB shared is to the sideport only 128MB.

First up is sideport only (128MB of course)



(Added) no sideport only 128MB shared.



Next was sideport plus 128MB shared.



Next, sideport plus 256MB shared.



Sideport plus 512MB, is identical as +256MB



And now No sideport but with 512MB shared

[charged3800z24]

Sorry to be hogging the past few post, I just finally been able to test this board lol.

I did a few test and found that I gained on average 100 points from 2000 HT to 2600 HT. Here are to SS.

Phenom II 965BE 4.1ghz 2800NB
OCZ BE 1600 8.8.8 24 T2 2x2GB
890GXM-G65 / 4290 1000 core 128MB SP 1333 + 256MB shared
Win 7 64
H20 Non-Chilled

HT 2000



HT 2600