Project: OSIDIAS (SFF taken to the extreme)

[craigbru]

I managed to make a few cuts today guys. I was having a z-axis plunge problem which you will see in the first video in particular. (I've got videos 2 and 4 linked below). Apparently it's an occasional problem with Mach 3. I did manage to get it sorted though, and got all my cutting done. Take a look!

http://www.livestream.com/losiastech...9-a1e822fd22be

http://www.livestream.com/losiastech...4-c4d584e05332

[Xion X2]

Ha.. I like your idea about mounting a camera behind the spindle; that's a nice effect. The only bad thing is that the video (the overall video not just the spindle-cam) is so low quality that it's tough to see what's happening.

I'm not a pro at video by any means.. still learning it. But I've found so far that Youtube seems to stream better than anything else I've found so far and with good quality. But you're doing podcasts, and I'm not versed on how that works.