Hi all, Ordered XT from Scan.co.uk, had a problem with one of the barbs, was bent not machined correctly when fitted into the block, was at an angle so not a fit tight and so would leak?
Contacted Scan, because of Easter opening hours I ended up ordering another one and will rma back after Easter.
Received the replacement yesterday, all of the back plate screw mounts are broken off and one of the barbs has the same problem I had earlier. So going back to Scan next week is an XT cooler with 2 bent barbs and a back plate with no screw fixing, not a good start, I hope the screw fixing don’t break off after the cooler has been install for a while, which leads me to my question when I mount the cooler do I screw the thumb screws all the way down i.e. until I run out of thread and wont turn anymore??
Sorry for the long post.
Using it on an I7 930 will update my sig when all up and running