DFI Lanparty UT P45-T2RS Banter starts here!!!

[stigma86]

Here is my settins to 450 fsb.What change if I 'd like to use in 475 or 500 fsb?
475 FSB
Thermal Management Control.......... - Disabled
PPM(EIST) Mode...................... - Disabled
Limit CPUID MaxVal.................. - Disabled
CIE Function........................ - Disabled
Execute Disable Bit................. - Disabled
Virtualization Technology........... - Disabled
Core Multi-Processing............... - Enabled

DRAM Timing:

Enhance Data transmitting........... - Fast
Enhance Addressing.................. - Fast
T2 Dispatch......................... - Disabled

Flex Memory Mode..................... - Auto
CAS Latency Time (tCL)............... - 5
RAS# to CAS# Delay (tRCD)............ - 5
RAS# Precharge (tRP)................. - 5
Precharge Delay (tRAS)............... - 15
Performance Level.................... - Auto

Voltage Settings:

CPU VID Control..................... - 1.2250V /MAX 1.2875V, but other mb was prime stable in 1.28V/
CPU VID Special Add................. - Enabled
CPU VID Special Add................. - Auto
DRAM Voltage Control................ - 2.03v /2.15V if use to 266/800/
SB Core/CPU PLL Voltage............. - 1.55v
NB Core Voltage..................... - 1.303v / 1.332??/
CPU VTT Voltage..................... - 1.224v /1.232?/
Vcore Droop Control................. - Enable
Clockgen Voltage Control............ - 3.45v
GTL+ Buffer Strength................ - Strong
CPU GTL 0 REF Volt.................. - 0.6250 /how set this?/
CPU GTL 2 REF Volt.................. - 0.6250/how set this?/
CPU GTL 1 REF Volt.................. - 0.6250/how set this?/
CPU GTL 3 REF Volt.................. - 0.6250/how set this?/
North Bridge GTL 0 REF Volt......... - 0.6750/how set this?/
North Bridge GTL 1 REF Volt......... - 0.6750/how set this?/
FSB Vref............................ - Auto

Genie BIOS Settings:

Exist Setup Shutdown................ - Mode 1
Exist Shutdown After AC loss........ - Enabled
AC Shutdown Free.................... - Enabled
O.C Clock Fail Retry Counter........ - 1
O.C Clock Fail CMOS Reloaded........ - Disabled
CPU Clock Ratio..................... - 8
Target CPU Clock.................... - 3600MHz /3800/
CPU Clock........................... - 450 /475/
Boot Up Clock....................... - Auto
CPU Clock Amplitude................. - 800mV
CPU Clock0 Skew..................... - 0ps
CPU Clock1 Skew..................... - 0ps
DRAM Speed.......................... - 266/800
Target DRAM Speed................... - 1130MHz /1190/
PCIE Clock.......................... - 100mhz
PCIE Slot Config.................... - 1x 1x
CPU Spread Spectrum................. - Disabled
PCIE Spread Spectrum................ - Disabled

I use to 10/07/2008 Bios.