Alright so here it is. The first thing I noticed, was that the glue job, is a bit sloppy and rushed by comparison



Also, the mold mark on the right side is still there, but is less noticeable.



So what did they fix? From the looks of it, I believe they thickened the outer walls of the back, but not the back itself btw



Also the screw holes were culprit #1. They’re trying to remedy this with smaller screws and gluing the "nut" into the original holes. Let’s hope they used a semi flexible glue lol.



By the way, the new screws are tiny!



Also, they didn’t seem to package the "washers" for the fittings, and included bigger o-rings for using other fittings instead. That impressed me a bit.



And who can say no to free bling? Well, not really free, I did have to sit around without a T3 for a while.

Darn image hosting failures making me use my backup hosting...