Wezly's Latest Money-sink

[Kibbler]

Hi Wezly,

I have a suggestion, I hope you can consider it, no commitment required. I must be honest, I'm not digging the tube routing right now (and deep down I think you might agree), please don't take that as harsh criticism. This is a very unique project and I have some ideas on aesthetics that might help.

You'll need 6 of these (or similar): LINK
And 4 of these (or similar): LINK

OR...

2 of these (but they're expensive, bulky, and I have no experience with them): LINK

And some more barbs/clamps, etc.

Ready?



-In parallel overall restriction will be lower so you can even drop down to 1/4"ID and keep things looking "light," not like a dense mass of tubing.
-I also just gave you a convenient place for a fillport (top left), if you don't have one already.
-Use p-clips or similar to secure each manifold to the top and midplate respectively.
-Where are your rads btw? Bottom compartment? If so, this should route the return line back down there perfectly.

What do you think?