Pretty nice, I'm surprised nobody slotted the inlet area in microchannel blocks until now... I did that a couple years ago in a prototype block I posted here. It's a good design feature.
It was "obvious" to everyone why the center area of the fuzion had that feature, yet none of the microchannel block makers seemed to realize the same physics apply there.
The next step after that is to turn that notch into a 3-5mm wide pin cross-slotted pin matrix across the entire inlet area, it's something I've been working on for a while. I'm just saying it here, now, so nobody can say I "copied" them if someone happens to do that before I get pics of my prototype out.
Reply With Quote
Bookmarks