Hi,

Revision 3 of my Scan_H20_V1.C

- Dual loop instead of single loop
- all tubing changed (I used only distilled without anything else but after 2 weeks... tubes were beginning to be a bit nasty... before filling I cleaned ALL components but anyway... I did it again an changed all the tubing
- 4 inline thermal sensors added
- full cleaning of all parts
- 4 silver coils (2 per reservoir) against algae
- 100mm res add, and EK Bay Spin res but used with bottom threads, not with the normal input thread
- removed the EKWB D5 Dual Top Acetal and installation of 2x EKWB D5 X Res Top Acetal

Some pics:

What I really want is that from outside... it's not possible to know that this is a watercooled rig I'm not that kind of tuning addict. I thought I was but I'm not. I'm looking for efficiency, not for building the sexiest possible.



Front view, you can see how easy I worked for fixing the top mounted 240mm rad... 4 screws, and dremmel to cut a part of the meshed plate.



Front view again, with EVGA ECP panel, res, you can see 2 silver kilcoil on the left side



Behing the 1st D5 pump with top, installed on a Gel Stuff from Petra's tech, no vibration, perfect match. And easy to access for changing the pump's speed



And now, behind the side panel....



On the bottom, you can see the other D5 pump with top, bot the VGA loop. The blue LED is not a tuning stuff... this is a part of the Aquacomputer Aquaero control system, I have 2 leds, one blue and one red, and depending on my settings, and on sensors information, brightness will change, color will change...



Closer look. CLAMPS EVERYWHERE Sometimes Koolance, and sometimes plastic clamps



Closer look on the bottom part of the case, PT Gel Stuff for the pump, very easy to change the speed of the pump (less easy than the pump upstairs but easy at all).



It's designed to easy maintenance process. It's easy to drain, and also easy to replace tubing, inline temp sensors, flow sensor...