Hi guys I'm wondering if this is a problem on my side

Haven't oc in a while when from f9e -> f9m on ud5 and turn back on HT

here is my bios settings

Code:
CPU Clock Ratio [20x]
QPI Clock Ratio [X36]
BCLK [200]

Advanced CPU Features
Intel(R) Turbo Boost Tech [Disabled]
CPU Cores Enabled [All]
CPU Multi Threading [Enabled]
CPU Enhanced Halt (C1E) [Enabled]
C3/C6/C7 State Support [Enabled]
CPU Thermal Monitor [Enabled]
CPU EIST Function [Enabled]
Virtualization Technology [Enabled]
Bi-Directional PROCHOT [Enabled]

Uncore & QPI Features 
Uncore Clock Ratio [x18]
Isonchronous Support [Enabled]

Advanced Clock Control
Base Clock (BCLK) Control [Enabled]
PCI Express Frequency (MHz) [101]
C.I.A.2 [Disabled]

CPU Clock Drive [ 800mV]
PCI Express Clock Drive [ 900mV]
CPU Clock Skew [ 0ps]
IOH Clock Skew [ 0ps]

Performance Enhance [Standard]
Extreme Memory Profile (X.M.P.) [MANUAL]
System Memory Multiplier (SPD) [x8]
DRAM Timing Selectable (sPD) [Quick]

CAS Latency Time 8 [9]
tRCD 8 [9]
tRP 8 [9]
tRAS 20 [24]
CMD [2]

Advanced DRAM Features:
Performance Enhance [Standard]
Channel Interleaving [Auto]
Rank Interleaving [Auto]

Load Line Calibration [Enabled]
CPU Vcore [1.21250V] [normal]
DVID [+0.18125]
QPI/Vtt Voltage [1.335V]
IOH Core [1.2V]
DRAM Voltage [1.66V]

Advanced Voltage Control 

CPU PLL 1.800v [1.8]

PCIE 1.500v [1.5v]
QPI PLL 1.100v [1.1v]
IOH Core 1.100v [1.1v]
ICH I/O 1.500v [1.5v]
ICH Core 1.1v [1.1v]

DRAM Voltage 1.500v [1.66V]
DRAM Termination 0.750v [AUTO]
Ch-A Data VRef. 0.750v [AUTO]
Ch-B Data VRef. 0.750v [AUTO]
Ch-C Data VRef. 0.750v [AUTO]
Ch-A Address VRef. 0.750v [AUTO]
Ch-B Address VRef. 0.750v [AUTO]
Ch-C Address VRef. 0.750v [AUTO]
I have C1E and C3/C6/C7 on so on idle multiplyer should drop right?

cpuz reading doesn't change much

thanks