800D Blood+ Project

[noeru]

It's alive!!!

You seem confused, re-read thread from beginning.

hello Weevil I respect thank you dear represent

HI Noeru! Yes confusing you here sory for that! Was refering to the rad fans in the top. earlyer you showed all internal. too tight?

buccaneer what rad are you talking about? Or has he sent you secret pics i can't see.

Sorry I'm late

It is a thing of the Top rad data XSPC RX480 125mmx58.5mm 25mmFan press - you can

Ha ha Only now I noticed that those fans are layinh lose on top of the case! indeed confuced me. nice work!!!!!!!

thank you　^^;　

Very nice set up. Are you running one loop with all? Did you end up using both pumps or just the one. Ca you take a pic of the pumps in the bottom.
Great work
Chad

Yes, it is one loop. Consider from watching the water temperature to change the loop.
Now DDC3.25x2 XSPC Dual Acrylic Top for Laing DDC is.

OOOO how are those fans?! i was looking at those. are they actually silent? can we get more pics of em?

SSD has taken the time to repair broken away
Yes, I want your photo shows ^ ^

Pretty nice work!.
I would like to ask you, which is the trip that the coolant makes on your system? and also, have you used 1/2 ID 3/4OD compression fittings for your tygon 1/2ID 3/4OD??
About the latter question, I will use the same specifications and well I am a little bit afraid that the compression wont be tight enough.

Thanks for your question if the answer is, I ask you a question again
yes,this Tygon 3603or3400 is 1/2ID 3/4OD This could ensure the flow of many
11/8mm was previously

Amazing job on spacing! I don't think you can put anything more to it.

Thanks If your reference