I've been having some problems getting my new overclock stable that i posted here
http://www.xtremesystems.org/forums/...postcount=3170
Heres my voltage settings
DRAM Static Read Control [Enabled]
Ai Clock Twister [Stronger]
Ai Transaction Booster [7]
CPU Voltage [1.40000v]
CPU PLL Voltage [1.50v]
North Bridge Voltage [1.39v]
DRAM Voltage [1.84v]
FSB Termination Voltage [1.36v]
South Bridge Voltage [1.05v]
SB 1,5V Voltage [1.50v]
Loadline Calibration [Enabled]
CPU GTL Voltage Reference [0.65x]
NB GTL Voltage Reference [0.63x]
DRAM Controller Voltage REF [AUTO]
DRAM Channel A Voltage REF [AUTO]
DRAM Channel B Voltage REF [AUTO]
CPU Spread Spectrum [Disabled]
PCIE Spred Spectrum [Disabled]
Cpu Clock Skew [Delay 200ps]
NB Clock Skew [Delay 100ps]
CPU Ratio Settings [08.0]
C1E Support [Enabled]
CPU TM Function [Enabled]
Vanderpool Technology [Enabled]
Execute Disabled Bit [Enabled]
Max CPUID Value Limit [Disabled]
These settings are 50 pass LinX stable and 10hrs smallFFT's stable so i know the CPU voltage is fine.
The problem is that when i ran UT2004+P95 Blend it failed at 1024 or 768 size FFT's after around an hour or so.
So i increased FSB termination voltage to 1.38v and got upto 6hrs UT2004+P95 until i stopped it (it didn't error out).
The wierd thing is that now after making this change LinX is no longer lasting more than 5 passes!!!!!!!
I've tried playing with the NB voltage and got no improvement, i"ve set tREF back to 3120T and also got nothing.
So what should i do???
Reply With Quote
Bookmarks