Hey, guys. I cut the L and U mounting brackets for the drives today. I should have the shelves cut tomorrow for the zero gravity chamber, and I'll post an update with pictures tomorrow night.

Quote Originally Posted by Vinas View Post
Well, I was thinking that when they are in the case it looks like two rubber parts. You can't really see what they are. We know that they are SSDs, but to add to the bling I'd show the tops off. In my build the SSDs are right next to the window and people always comment on it at LANs. Anyway, it's just a thought. Instead of two boring rubber looking devices I'd show the tops off so you can see what they actually are.
The top stickers will show just fine. The drives will be right up against the window; I don't think anyone will have any trouble seeing that they're OCZ drives. I don't want to slant the drives because I think that would take away from the weightless appearance that they have when sitting perpendicular to the window. Also, I want the res tops to be able to show clearly from behind.


Quote Originally Posted by Weevil View Post
You would be hard pressed to find one person on these forums that wouldn't know what those " rubber looking devices" are.


Quote Originally Posted by kgtiger View Post
If I remember correctly Xion, way back when I was an apprentice.
.050" is 18 gauge, which is 1.4mm.
If you are just cutting straight lines then try cutting the ali with a very sharp knife, like a Stanly knife and straight edge.

A bit like the perspex. After 2-3 hard cuts you should either be threw it or really close. Then just bend along the cut, keep flexing and it will brake.
Will need a quick file to clean up.
I might try that, thanks.