45% + 1.4v = 2v ...I dont think you have anything to worry about..Your screeny doesnt show any OCP value that I can see...am I missing something? The only value I can spot is your GPUv...which says its at 1.12v..a long ways from the 1.4v you stated...
OCP works off of hysteresis ...so changing VID bumps OCP...but with these Voltera IC's it appears that VID does NOT change..only GPUv..so VID/OCP limit stays the same..Have you tried to see if the OCP mod for the 5870 is the same as your GPU..?
"If you wield a sword you must be intent on cutting the enemy" - Musashi
Yes u are missing tha i hardmodded the card!!!Originally Posted by CL3P20
I dont use software i mod with a VR!Far steadier!!!
2)How do i do that?
From what i saw u need to remove a resistor completely and then solder a 18kohm one right?But 5770 has different volt chip...What leg of the chip was the 5870 resistor connected to???
So i could search my chips datasheet and experiment...NO WAY I REMOVE THE RESISTOR THOUGH!!!!DID U?
8400@4,5GHz 9*500@1,506volts
DFi X48 T2RS
BALLISTIX 6400@1200mhz 6-5-6-15@2,1volts
XFIRED 4850s 1GB 820/1150
Thermaltake 600rx (aging)
Posting Permissions
Reply With Quote
Bookmarks