Can anyone give me a hand helping me get 4.0 stable please.
My cpu is a i7 920 D0 , i have it rock stable at the folowing settings , if i try 20x200 i can only get it stable at 1.294v witch doesnt sound right so mutch more volts for a 200mhz jump . Iam watercooled and temps are ok

My Stable Settings for 3.8

Advanced Cpu Settings

Cpu ratio Setting ...................[19]
C1E Support .........................[Enable]
Hardware Prefetcher ..............[Enable]
Adjacent Catch Line Prefetch ...[Enable]
Intel Virtualization ..................[Enable]
Cpu TM Function ....................[Enable]
Execute Disable Bit ................[Enable]
Intel HT Tecnology .................[Enable]
Active Processor Cores ...........[All]
A20M .....................................[Disable]
Intel SpeedStep Tech ..............[Disable]
Intel C-State Tech ..................[Disable]


Ai Overclock Tuner ................. [Manual]
CPU Ratio Setting .................. [19]
Intel Speedstep Tech .............. [Disable]
BCLK Frequency ...................... [200]
PCIE Frequency ..................... [100]
DRAM Frequency ..................... [1600mhz]
UCLK Frequency ..................... [Auto]
QPI Link Data Rate ................. [Auto]


DRAM Timing Control: Auto
____________________________________

CPU Voltage ........................ [1.20v]
CPU PLL Voltage .................... [1.82]
QPI/Dram Core Voltage .............. [1.25]
IOH Voltage ........................ [1.10]
IOH PCIE Voltage ................... [1.50]
ICH Voltage ........................ [1.10]
ICH PCIE Voltage ................... [1.50]
Dram Bus Voltage ................... [1.60]
____________________________________

Load-Line Calibration .............. [Enable]
CPU Differential Amplitude ......... [Auto]
CPU Clock Skew ..................... [Auto]
CPU Spread Spectrum ................ [Disable]
IOH Clock Skew ...................... [Auto]
PCIE Spread Spectrum ............... [Disable]

Thanks in advance .

Also posted this on P6T Deluxe thread but no luck with replys