Quote Originally Posted by aka_GK View Post
eponymous
just few simple rules I made for myself:
1) Don't be in a rush
2) Don't do it in the late night
3) Take some masking tape and make the accurate labels for each wire, then double check them according to connector reference.
4) Take the photos of each step
5) Try on old PSU first - your new PSU do not want unnecessary pin ins and outs
6) Double check the labels and numbers on the connector before putting pins back
7) Cut the heatshrinks right

You will be fine
Hi aka . The thing is I did all this. I always take my time with stuff as you can tell from my proj. log :P

The main problem I had was that the labels had to be relocated from the pins to the braiding at one point which I will discuss when I update my log (complicated crap I've been doing with this connector, lol).

I guess the labels weren't sticky enough to stay on the braid