Thanks a lot for the nice comments guys!

---

So this is what happen after my last update:

I have started to mount the gear inside the case but I also made a simple hold down plate for the ROG chip

The problem when you use EK waterblocks NB/SB water block is that you don't get a way to fasten the heat sink for the ROG chip.

I made a simple plastic plate and drilled two holes to use as bracket to hold the heat sink in place.



Bracket was made from an old plastic 5.25" bay shield.





Screws used is black M3 16mm and M3 nuts.
The screws closest to the NB/SB water block was too long and I had to use a rasp and wet dry sand paper to take them down to 12mm.





I hope the chips on the bottom of the ROG chip don't get hot since I placed the plastic bracket on top of them.
Placed some thermal adhesive tape between the plastic bracket and the chips, hopefully this will be enough





The cable got some sleeve





Finished look
.
.
.
.
More pictures sooon