Post Rad Chiller Concept

[zoson]

Man, you all need to work on your reading comprehension, not to mention picture comprehension.
The hot side would be cooled via heatsink(seriously, did you even look at the pictures?). Not water, so it wouldn't be dumping the pumped heat into my water loop. It would be dumping it into the air.

The idea is that my heating elements dump say 300W of heat into my loop. My radiators dissipate about 300W of heat at a delta of about 7C. So if I add a cold side of a peltier moving even 50W of heat out of my water onto a heatsink.

And the whole POINT of doing it like this is so that you _CAN NOT_ get below ambient, and insulation would be unnecessary. Efficiency be damned. I'm just trying to control my coolant temp a little more, and I've run out of space inside my case for radiators, but I *could* fit an 80mm device like this.