Single PCB GTX 295 Vcore mod

[LardArse]

I think no need so troublesome just 100ohm between 2 points will do it:

[massman]

I think no need so troublesome just 100ohm between 2 points will do it:

Will this work around the OVP? Or do you have to do another modification to remove OVP?

[EvoCarlos]

lol removing it is not the problem... placing it back would be problematic, it's really small
but if you remove it then you have a trace that normally ran from the first side of the resistor to its other side... so in reality you'll break a trace, it will lead nowhere... know what I mean?


I just don't feel comfortable possibly killing 2 cards (yes I have Quad sli)

you can always just bridge the to pads where the smr was with solder that will work the same as the smr

Will this work around the OVP? Or do you have to do another modification to remove OVP?

i need a mode stops it from black screening after 1600 shader
my card want so go so much more but this problem is annyoing

shammy please guile me the right way

[EvoCarlos]

I think no need so troublesome just 100ohm between 2 points will do it:

just tested this style
points read 4.1ohms stock
after fitting 100ohm vr gives 3.9ohms
once running any ajusment of the vr shuts the core/s down

any ideas peter?