What I did was get it semi stable or boot-able then tweak one setting up and down until I could see / feel what spot was more, stable again just by watching my temps while running burntest for the most part then leave that setting at the best spot and go to the next one and do the same thing. The FSB Term has different names, it depends on the board. I'm sorry I don't know all the names.
It was the fastest I have ever been able to set all my settings, honestly. So, if your CPU GTLs were the most stable say at 63 because .67 was 2 minutes and lets just say you went to .59 as well and it was one minute then stay at .63 and move to the next one. I think if you were to watch your temps while benching you would see what I am talking about.
Edit: Here I am home now, this is at 490 x 8.5.
This is at 470 x 8.5. I didn't feel like doing the big one again so I just did 1024. I think I could actually use some GTL tweaking again here since I changed the FSB and I could probably get better here as well I think.
I know my temps are a little high but, this cooler can't handle much more. I need to get water. I figure no other programs or games get it this hot any way. Prime95 only gets it to 75C tops I believe.
Reply With Quote
Bookmarks