distance between EK-FC285 GTX PCB Rev.2 in 3SLI

[ell]

here is the filing modification i was talking about, this came out of someone else's build log:



notice the top right corner of the block, and without filing it would foul the small black block in the way.

as for my temps, I dont know the temp of my room, and I dont know the temp of my water, all i know is that with a pair of 285 GTX 2GB's with ek blocks without standoffs using arctic silver 5 with a feser quad rad and 8 fans in push pull and a mcp355 18w with xspc restop with distilled + pt nuked water my load is 45c MAX.

as for the instructions you posted, i've never seen them before, i was sent these : http://81.90.180.2/ekwaterblocks/sho...0046993892.pdf

if you used standoffs try remounting without for better contact and pressure.