Here are some quick results@4.5. This obviously is not Prime stable yet(will probably need 1.45V), but so far stable enough for my purposes. Yesterday I was priming at 4.4 and kept getting errors no matter what Vcore. Temps were topping out at 73C. Some of you guys have talked about this issue, Prime failing if temps get above a certain point. I realized my 38mm fan was installed backwards (pull config), switched it to push config and temps went down to 63C top, and no more errors. Im sorta glad I didnt get one of those crazy low vids, as I really am liking my temps at my Vcore.