[Sub-Preview] Heatkiller 3.0 LC and LT Compared + Vapor's Testbed 2.0 First Look

[rge]

actually, isn't that upside down rge? I thought the lettering was meant to be readable, or are you getting better temps that way?

Not sure how it is meant to be mounted, but probably so writing is right side up.. but I want the outlet higher than inlet if vertical, just to avoid potential for trapped air when first bleeding since bubbles rise. I doubt it would make any difference either way temps wise, but have not tested it other way. Dont even know if HK will temporarily trap bubbles when first bleeding, but I have had other wb that would depending on mount position, and have to jiggle/tap them while bleeding. But now that you got me curious....may have to test the other way and see...