Quote Originally Posted by rge View Post
What kind of paint did you use on the motherboard tray and inside of tj07?
it was a dark grey primer - then i did a very thin layer of plastikote daily for about a week to ensure a nice even coverage

today i painted my pci plates and managed to get some black thumb screws for the pci panel and the rear/side panels of the case





currently painting my single slot graphics plates and sound card plate in the same way



after the advice on my pumps and trying to take the common sense approach i decided to redo my pump mounts

i used the technique i described earlier in the thread by using the rubber stilts from the striker motherboard and putting some space under the pumps