Quote Originally Posted by millertime359 View Post
I would honestly get a DDC with the XSPC restop instead. I think it would be a cleaner install than putting another D5 and MCRES-Micro in there.

The EK block should work. You could use the SLI bridge, or some D-plugs and just run them in parallel. Make certain to check reference design though before purchasing blocks. I don't think you need to water cool the 9800 GT, what temps does it reach?

You really don't need to put the board on water, but if you did, just loop it in with CPU and a 360 rad, and you should be fine. As loong as you have some airflow or a fan pointed at board, it should be fine.
First, thanks for the quick response.

I'm pretty new to the whole watercooling so I chose the same pump/res for familiarity/consistency in the case but I will consider those options.

Haven't seen the EK block but it looks pretty nice... need to do some research on it.

I'm with you on not putting the board on water... the dominator GT fans provide decent airflow to it when positioned right. Not to mention I will eliminate A LOT of heat from my case with the cards on water.

I should point out I don't have the Physx card yet but think I should add it because if I watercool without it and want to add it later I'm screwed.