Certainly learned a lot from this thread.

Hopefully I can share something that worked for me.

Well first of all, those molex extractor tools didn't work for me, I have the Corsair HX520 and the pins are an ass to remove.



They need to be made of Adamantium or something, someone get Wolverine.....

These worked best for me (credits to dingdong555 ), plus they are dirt cheap, less than 50 cents :



I had an extra tool as well, something to help me pull out the "super hard to remove" pins, couple bucks down at ACE Hardware :



They have no sharp teeth, so they don't "bite" into the PVC and tear it if you squeeze and pull too hard :



Ok a little demonstration of how I did it :

Get your tools ready :


(sorry can't resist the shot )

Put on your gloves, it does help reduce injury when you yank the cable out, trust me, you WILL cut yourself (maybe I'm just clumsy)



Push one pin in until it can't go no more :



Push the other pin in and make sure it's aligned, so you know it went all the way in :



Then just simply use the tool and yank it out



Done!

Thanks Dangals for starting the thread, Guys who contributed (too many to mention), Charles and Nils for the best sleeves ever!

I'm kinda addicted to sleeving, but I just have 4m left of the 1/8 lol