G.Skill Trident triple channel kit - DDR3 @ 2000 MHz in test

[zoqiet]

The only config I could get these to boot in was 10xRam Multiplier and 20xUncore with 200Mhz FSB 1.65Vram and 1.5QPI ..

But same settings 10x180 would not post.. I am going to RMA the set and pick up the Mushkin XP3-12800 Redline which are supposed to have the BBSe's in (keep my fingers crossed).

Also when switching Mobo's I am looking between the DFI, UD5, or P6T Deluxe V2? Any opinions on which one would be the best?

Your problems are most likely with the Uncore and IMC, not the RAM.
For the motherboards I'd say DFI > P6T, UD5.

.....

Finally figured out what were wrong with my dimm channels as one dropped out on C6. And I blamed the poor sticks. :<
Trident's currently running at 1600mhz 6-7-6-20 @ 1.53volt linX stable. Not bad sticks for 120euro tbh!