Can anyone rate the primochill Typhoon III?

[BoxGods]

Let's not mention the fact that the single T3 will power two rigs in teh build (and one PSU). No, that would just be showboating. Four 3d monitors built in would also be a little grandiose

New rule. Your mod can't be taller then you are. Or weigh more

I'm looking to put upgrade to watercooling for the first time and will be running a single loop to just my i7 and motherboard full block, do you guys think it's worthwhile to buy the T3? Will it with the MCP655 perform better than an MCP355 w/ XSPC Res top for a CPU/Mobo only loop?

And I saw some others mentioned installing it in the ATCS 840 and that they had a little trouble because of the tool-less 5.25" bay mounts? Do you just have to totally remove the retention mounts and just use screws?

Well, although the performance on 2 loops is amazing, the single loop performance doesn't exactly suck lol. Its middle of the pack for pump tops. As another poster pointed out, its also good to have that second loop ability if your going to add other blocks down the road. Call it future proofing.

As for your case, several guys have posted pics of their T3's mounted using the rails.

Any word on the availability of this?

Also FrozenCPU.

I'm curious to heard a pump with this res/top, because there are no noise dampening ...

PS : Sorry for my realy realy bad English

We all speak case modding and water cooling so no worries.

There is actually quite a bit of MASS to the T3. It is not a lightweight part. There are also 8 rubber mounting washers included that isolate vibration.

Short answer. Once all the air is properly bled off (as with any pump) the T3 is very quiet. Certainly quieter then 2 DDC's would be (and in some cases the T3 will beat TWO DDC's on performance as well).