Well I took the pics but I dont see a way to attach them except via url. I was going to upload the pics I took. Am I doing something wrong?????
Also do you guys think this is a software e.g. bios issue that will be resolved if so I will call tigerdirect to rma this ram and tell them just send me another set of the low volts. I have a patriot viper set which do work at 1081 with tighter timings but they want do 1100 for me and I dont want to use higher voltage becuase I dont know how they respond and if life will be compromised with over 2.15v. I have patience to wait a few months to use a ram which I know is the bomb but If you think it will never work please tell. Also I told gigabyte tech to please in next bios revision give some more flexibility as to voltages and add a few negative notches -.1 to -.2 so that people with issues like me can manually tune the ram to desired voltage.
Also tried the bus overclocking but my board will not allow me to use anything above about 250 ht. Dont know what it is but I lowered nb multi and ht link multi and it still would'nt boot just a continuous loop, like the fans would rev up the down a little over and over and no screen nor post.
Also on my board and I would assume yours, the ram is increased in .1 increments. If it were in .5 I would be ok because if you remember I said normal gave me 2.05 (like it was auto) but +.1 gave me 1.95. Sucks they dont have an auto then 1.8-2.4 volt range, not auto the +.1 and so on. the First one above auto should be a manual starting point at 1.8 volts, not some +.1 over.
Reply With Quote
Bookmarks