Ok my Sammy(s) build has been forever in the waiting-life has its bumps sometimes. anyways I am setting up the board, drive and PSU on a nice clean shelf so I am going caseless. After doing some reading which metal prongs at the bottom of the board i am supposed to touch together with say, a screwdriver, to jumpstart the board? I tried last night a few times had the lights on the board once I had it plugged in; but the lights seemed to flicker on and off. Now I figure i am doing this all wrong. Also I am going to setup another board and all the components just to make sure it is not any of the parts.
Just to double check I have a bunch of 2gb and 1gb for all my boards-if for now I am only placing 2 of each( of course just the same number) which slots would they go in?
Thanks guys