Quote Originally Posted by Oztopher View Post
Seems everyone's having the same problem with the EP45T-UD3R... i can't get mine to run at 1600 CAS 7, like my ram is rated for. I have a 2x2GB OCZ platinum kit, 1600 CAS 7, 1.9v.

I can get it to boot, but as soon as i run prime blend it fails immediately. No matter what timings, voltage and strap i use, it's all the same...

Now, i started playing with the driving strengths, and these made a huge difference ! set them all to +8, just for the sake, and it made it last 10-20mins on prime blend before fail... quite the difference.
Too bad the board doesn't have the driving strength profiles... it's hard to tune all 8 settings for both channels

Does anyone have any experience with the driving strengths? care to share ?
i dont know if it is or not but raise the volts up 2 noches with the ram but i thught 1.9 will be low to dont go any higher that 2.1volts if your running stock latencies if that dont work only try 1 stick of ram and then the other stick to check if its the ram at fault but also try the memory in diferent slots as well thats all i can think of to be honnest if that dont work i really dont know