Asus M3A79-T Deluxe

[gOtVoltage]

how is that possible ?

my board sometimes resets :/ but it' like the hard drive starts acting weird and slow.


sometimes it get this weird line before it boots too.

Ive had that happen too. I thought it was just me...I also Noticed that the Temps on any CPU read hiher than the 803Bios with 905... So ill be trying the 1001 Sunday.

probably "Auto" Vcore isn't 1.45V anymore

Exactly,, Also i think they Fixed Temp sensor reading too or lowered it.

Does anyone see a option for unleashed yet.? I really wish they would for this Mobo

[Daveburt714]

So ill be trying the 1001 Sunday.

Does anyone see a option for unleashed yet.? I really wish they would for this Mobo

Good news and Bad news GV...
I flashed 1001 tonight, so far so good.
Still NO "Unleashed" option.

I haven't tried with this release yet, but 905 was giving all kinds of problems with saved BIOS configs (could have been the beers I guess ).

[Tom128]

1001 seems a bit weird to me. I flashed, restarted, all my settings were back to auto. Loaded my OC profile and restarted, was prompted to redo BIOS again. Repeated, same. Then I just went in, saved it with everything still on auto, restarted, and it stopped prompting me to go to BIOS. Restarted again and it let me keep my settings after that

Seemed fine after that but then I went back to testing my max OC with C&Q enabled. For some reason it does not like always restarting now with voltages over 1.45v when it used to restart fine. I just now had to resort to flipping the switch on the PSU and waited a few minutes and then turned it back on and it seems fine, not even a no-post warning. The reset button and holding down the power button would not post, the PSU switch was what I HAD to do to get it running. Not sure why my method to turn off/restart mattered but oh well.

On the bright side of things I am up to 3,829Mhz (18.5x207) on my 955BE at the moment and C&Q is still working just fine