Gigabyte EX58-UD5/Extreme Discussion Thread

[phsinc1]

Hi,

Rig Set up:
Intel Core i7 920 D0 Stepping (SLBEJ) 2.66Ghz
OCZ Gold 6GB (3x2GB) DDR3 PC3-12800C8 (1600MHz) Tri-Channel

System is water cooled and shows as around 27c in bios idle.

OC settings are as per the pics below for a 4GhZ OC.
I purchased this set up as a pre OC'd bundle from overclockers.co.uk.

I wanted to ask if these settings was the best and should I be concerned about anything set. It is more curiosity since the OC has not been done by myself.

Feed back please?







Thanks

I see your QPI/VTT is set to Auto, check with ET6 the correct value

[Godmyster]

Should i use the latest bios for my UD5 or stay with the F7c? im using a 920 C0

[boldenc]

anyone know what "Round Trip Latency" exactly do?

mine are Auto set to /55/57/60

Can I tweak them?

[MonsterDK]

I see your QPI/VTT is set to Auto, check with ET6 the correct value

I'm not sure what you mean by this exactly.

But this is what I looked at (??) Easy Tune 6 Clicked Advanced under the Tuner option, then Voltage 1.

Then looked up QPI/Vtt Voltage. Under 'Power On' it shows 1.53500V

Is this the value I was looking for or am I way out?

[phsinc1]

I'm not sure what you mean by this exactly.

But this is what I looked at (??) Easy Tune 6 Clicked Advanced under the Tuner option, then Voltage 1.

Then looked up QPI/Vtt Voltage. Under 'Power On' it shows 1.53500V

Is this the value I was looking for or am I way out?

That's too much, try to manually set it to 1.335v or 1.355v

here is my settings for 3.82GHz

http://www.xtremesystems.org/FORUMS/...postcount=2876

"Target" are the Values currently used

[Godmyster]

Anybody?