Quote Originally Posted by SoulsCollective View Post
Haven't tried running with two sticks - but if it doesn't work with one, why would it work with two? Regardless, I'll give it a shot.

Current BIOS is the latest non-beta from the DFI website.

I was mistaken - it's a C0. I always knew it was the old revision, just wasn't sure what was what.
Okay, here's my cf or 88 clear procedure. I have to do this often on this board but it absolutely works.

1) Shut down system and disconnect power source via plug in psu.

2) Press power button to fully discharge board

3) Clear cmos using either jumper or power reset method

4) Plug power then power up.

Board will cycle CF first, hold then C1 the a couple things before c26. If powers off after c26 then just unplug again but skip clear cmos. After 26 you'll get beep and all will be fine.

Do this with two sticks of ram. Because you have a C0 chances are the memory controller may be weak and struggling with 6GB of ram. Your bios is okay for your hardware but your board is definetly behaving as though there's a memory issue. Makes me wonder if you do have elpidas under those spreaders. Which would work better with 4/28 regardless of C0 or D0.