Quote Originally Posted by Shoggy View Post
As said, speed control is no problem but the shutdown will only work when you forward the rpm signal to the mainboard or aquaero.
Yeah I just wanted it confirmed that i had understood correctly. Because I don't want to use any manual switches and stuff. Just go in the program and set the pump to lets say 20% and 56% if i want to. Just with the help of the software and my mouse.

Forwarding the rpm's signal is easy? Or does it require some special stuff?

Quote Originally Posted by jcool View Post
I use the BigNG to control MCP355 pumps.. just set the voltage corresponding to the water temp (i.e. 8V at 30C water, 9V at 33C and so on) and it'll scale your pump automatically according to your water temps. Theoretically the poweradjust should be abl to do the same.
However, you'll need to solder the wires of the pump to a 3pin fan connector first.
Yeah, This will be no problem. I just want 1,5 GPM at the pumps and leave it like that. Because after that there is almost no gain in temperature i have been told. Maybe thats incorrect.