Micron D9 GMH\GKX\JKH etc club

[Don_Dan]

This is my first "back-to-topic" post, guys!
I hope the rest of you does the same and shows some results.

I could go higher, so if my board allowed stable ram speeds of 666MHz I'd guess it wouldn't have issues with PL7 at 500 FSB. The UT/DK P45's/UD3P's do clock ram better than my M2F so 500FSB PL7 / 666 MHz stable may well be a possibility on those boards. Someone try it

Long time no see in this thread CryptiK...

I remembered this post made by you some time ago, and now that I had some time to test and tweak my RAM, I just tried what I could get.
Used my usual test system, E8600, UD3P and my beloved Crucial 10th Anniversary Edition.

This screen is dedicated to you:


Most voltages and settings can be found in the screenshot, this was the closest I could get to 500MHz FSB, cause I was testing in 5 MHz steps. 500MHz was semistable, saw it on CPU-Z, but it froze when I ran Everest.
500MHz FSB + 666MHz RAM should be doable with a bit more tweaking, but not now... I'm too tired...