Asus P6T6 WS Revolution triple-chip block preview

[eclipset]

http://img16.imageshack.us/img16/1006/80383841.th.jpg[/IMG][/URL]

I purchased the Waterkiller CPU block as well. Copper version supposidly works better than the delrin aka POM (black) version that six used in his original photo of the P6T6 blocks.

My question:

Which barb did you end up using on the MIPS chipset block? Are they 1/2 inch inner diameter? I may use barbs to save money since compressions could run 150 bucks for a full set. I like the look of compression fittings and ease of installation but the price is a bit more than I want to spend for a fitting. I am somewhat undecided overall.

[hitachi974]

Think you misunderstood. The small mosfet block usually has to be installed 180 degrees rotated.

OK, thank you Six, I had not seen

[hitachi974]

I purchased the Waterkiller CPU block as well. Copper version supposidly works better than the delrin aka POM (black) version that six used in his original photo of the P6T6 blocks.

My question:

Which barb did you end up using on the MIPS chipset block? Are they 1/2 inch inner diameter? I may use barbs to save money since compressions could run 150 bucks for a full set. I like the look of compression fittings and ease of installation but the price is a bit more than I want to spend for a fitting. I am somewhat undecided overall.

I think you want it

http://www.materiel.net/ctl/Embout_W..._fil_1_4_.html

http://www.docmicro.com/pieces/DocMi...tre-_7710.html

http://www.koolance.com/water-coolin...product_id=503

http://www.koolance.com/water-coolin...product_id=485

High-Flex 10/16 and I just grill two 280 GTX on my TJ-07, I had three to start