Perusing Laing's website and found this...DDC 3.25?

[Waterlogged]

But it is the only one that allows me to use rubber isolation bushings to mount them in MM 3.5" drive brackets mounted to 120mm fans. Two birds with one stone, great mounting along with constant airflow across the pumps.

http://www.performance-pcs.com/catal...ducts_id=22224

Ohhhh Edy, it sure would be nice to have some EK rev2 tops with tapped holes for the same mounting method....Hint, Hint.

I know SiG, that was one of the reasons I got it but...alas, QC seemed to be off the day mine was made. It chipped out right where the screw thread comes close to the hole for the outlet.

(Click images for bigger images)


It fried 1 pump and shorted a second to about half power before I found the problem. The second pump has since succumbed from it's wounds. Both pumps were DDC-2's. I recently thought I'd found a fix for the top by sticking a short section of O-ring Buna from a repair kit I have up the threaded hole and let the screw squish it thereby sealing it. It worked well enough for the video I made comparing the DDC-2 to a DDC 3.2 but I found a few drops of water in the lower chamber of the 3.2 when I was done so that top is now officially permanently out of service.