Quote Originally Posted by chew* View Post
Bingo,

Any thoughts as to why my port 80 diagnostic card is registering FF throughout the whole boot cycle?

It's installed in the available PCI slot visible in the pic in above post......

I really hate not knowing why a setting fails to boot..

seems I need more voltage to get my OCZ's to even boot on this board than the gigabyte......only needed 2.25 for 1180mhz on 790gx and they were 100% stable, they boot into memtest at 2.3v but are tossing alot of errors.....will have to tackle drive strengths tuesday.....
I have no idea, still trying to figure it out. My POST codes are just fine actually. However, I am able to reach DDR2-1300 now but my NB speeds are limited to 2.6GHz on two CPUs that both did 3.1GHz on the 0903 BIOS. It is always something.... I have a meeting with them tonight.