DFI LP UT X58-T3EH8 - First bench, bios screens etc

[cstkl1]

Hello all and nice to meet you here. Yesterday I bought this DFI and its paired with an 920 3842A and Adata 6Gb 2133X. Since i run with intel stock cooler atm, cause i wait for my new case, i made some mild oc tests to see what this baby can do. I must admit that this combo is really sensitive in voltage adjustements. But i have two questions atm: 1. Is it normal that DFI Led screen post FF while in normal operation under win? Thats what its supposed to show? 2. Currently testing 21x181, cpu 1.25v idle-1.22v load, VTT 1.26v idle/load, 1.55v dimm at 1800c9. Is it normal to need more vtt than vcore?

hope i am not quoting wrong but eva did mention something about vtt to vcore..

but generally dude.. x58 is pretty straight forward in eliminating voltages thats the cause of the problem. this mobo has very little flux and almost exact voltage which helps a lot in doing this.

try the few above post for suggestion.
cause question like this is so vague and ppl have to assume u found the right vcore for ure cpu speed, u found the right vdimm, etc etc etc before somebody comments on what vtt should be set.
unless u can be specific and mention that u already found the vcore with this test etc and the dram speed and timing etc etc..

nice rams again.

cause the general consensus is going to say the vtt is too low
but from what i have seen with eva and others posting.. every proc vtt voltage is a mystery.

btw mine also runs with ff posting