Core i7 920 rev D0 stepping 5 :)

[ewitte]

Those volts are crazy lol. I have not went over 1.35v and that was good for 4295 pi and only limited by QPI. Probably good for 4.4Ghz at 1.35v if I rely on turbo

[okorop]

Those volts are crazy lol. I have not went over 1.35v and that was good for 4295 pi and only limited by QPI. Probably good for 4.4Ghz at 1.35v if I rely on turbo

I agree

[Leeghoofd]

Those volts are crazy lol. I have not went over 1.35v and that was good for 4295 pi and only limited by QPI. Probably good for 4.4Ghz at 1.35v if I rely on turbo

Not all CPU's are alike, mine even needed 1.4Vcore for just 4ghz stable ops, my new one seems better not even close to your cpu ( estimating 1.28-1.3Vcore for 4ghz ops ) It's not because it's a new stepping that it automatically means lower Vcore... If Intel just got their memory controllers up to scratch that would already be nice...

I agree

you agree on what ? too high voltage ? ow c'mon he will not run them volts 24/7

[ewitte]

Not all CPU's are alike, mine even needed 1.4Vcore for just 4ghz stable ops, my new one seems better not even close to your cpu ( estimating 1.28-1.3Vcore for 4ghz ops )

4.05 runs at 1.225v (only tested with HT on) though I only left prime open for 10 minutes because the temps where getting close to 100C. My guess is with the correct temps that would be stable because 1.2v still runs prime for about a minute. Until I have the temps under control not sure if it has to bump up to 1.25 or not.

Still going prime (7 hours) 3.6 @ 1.085v