How to set up GTL Ref Values for 45nm & 65nm

[OnDborder]

Depending on my fsb voltage, I'm having luck with -40's or -45's straight across. And +50 on the nb.

[CryptiK]

CryptiK, with the Maximus II Formula and P5Q-Deluxe
you used to do the same GTL over on your e8400?

Only did relatively brief stability testing on the P5Q-Deluxe as I just bench on it and run the M2F 24/7, but I was around the same Vref on both boards.

I run +60/+20/+60/+20 on the M2F and 0.680x 0/2 & 1/3 on the P5Q-Deluxe, both with a Vtt of 1.25v giving a vref of 0.85v on both boards.

does any one know how the gtls on the dfi=ut-p35-t2r operate?is it percentages or mv?

No idea, theres a table somewhere you can DL that explains them IIRC. I'm pretty sure mikeyakame DL'd it for his DFI although its an X48 maybe give him a pm and see.

I think that's a myth along with offsets. But you can try -45 -45 -45 -45, and if u get load drop then try +45 +45 +45 +45. I'm eager to know your results too.

Wafer thickness in nm is not what to set your GTL Refs to. 65nm and 45nm do behave differently, but whatever works best for you.