i'm at 495fsb with a q9650 but i just can't get the last 5mhz. every time i do, the system locks up and freezes everything. even pressing the reset button will take about 3-5 seconds before it actually restarts. what is causing this type of freeze instability? i'm suspecting it's my memory. i'm writing down my settings right now and i'll post it in a bit
edit: here's my bios settings that i tuned myself:
Code:Processor: q9650 OC From Memory Level Up: Auto Ai Overclock Tuner: Manual FSB Frequency: 500 Ratio CMOS Setting: 6 CPU Clock Skew: -200ps NB Clock Skew: -100ps FSB Strap to North Bridge: 333 MHz DRAM Frequency: 1601 MHz DRAM Timing Control: Manual 1st Information: 9-9-9-28 (all other subtimings on auto) DRAM Static Read Control: Disabled DRAM Read Training: Disabled Ai Clock Twister: Auto Ai Transaction Booster: Auto EPU II Phase Control: Auto PCIE Frequency: 101 CPU Voltage: 1.34375 Load-Line Calibration: Enabled CPU PLL Voltage: 1.55081 FSB Termination Voltage: 1.39166 North Bridge Voltage: 1.51097 DRAM Voltage: 2.00131 South Bridge 1.5 Voltage: 1.55081 South Bridge 1.1 Voltage: 1.10014 CPU GTL Reference (0): +60mV CPU GTL Reference (1): +20mV CPU GTL Reference (2): +60mV CPU GTL Reference (3): +20mV NB GTL Reference: +40mV DDR2 ChA Reference Voltage: Auto DDR2 ChB Reference Voltage: Auto North Bridge DDR Reference: Auto CPU Spread Spectrum: Disabled PCIE Spread Spectrum: Disabled





Reply With Quote


Bookmarks