Micron D9 GMH\GKX\JKH etc club

[Mr Roboto]

you lose a bit of bandwidth but i can do 1200mhz 4x1 2.06von dfi x38
on dfi ut p35 i can do 1180 4x1
4 sticks always harder on north bridge and need xtra volts on nb and ram
but who cares its not like you gonna keep your board over 2 years

this is my max with 4 stix

Awesome. I was getting really low write\copy with my memory. I thought it was just the board (which part of it is I'm sure) until I swapped in a E8400. Now my read\writes are fine but the copy is still really low. It gives no increase between my Q6600 or E8400 and dividers don't increase it either, 3\2 being the best result. I saw someone else with a 680i getting normal copies in the 10,000MB/s+ range with similar or even slower memory. Any ideas?

Here's a shot with my E8400 at 1280Mhz 5-5-5-15 dual channel.


With a bit of tweaking 5-4-4-12 (tRC) 18 and (tWTR) 8 I was able to max it out at 8,555MB/s.