Retail Q9650 Overclocking Thread

[banny]

Running OCCT now, have had to increase the volts in bios to 1.4250v and CPU PLL to 1.56v.
done 5 mins so far with no errors, will see if it pass's the full hour. vcore in this program sais 1.34 though so board undervolts quite abit.
Using loadline calibration in bios.
failed after 8:32
shall I keep on increasing vcore.
temps got to 74c on one core, pretty high considering I am under water.
water consists of 120.3/D-Tek fuzion V1 with quad nozzle, XPSC NB block, Asus 3a mosfet blocks, solid copper SB heatsink. Pump is 18w DDC with flexitop.
vcore listed as 1.38 in OCCT.
testing again 1.43150v in bios, this drops as low 1.34v at some points under load.