**Unified** DFI LanParty UT 790FX-M2R-M2RS / Phenom /Data Base Thread**

[pershoot]

I always set Vdimm higher right from the start, always around 2.1Vdimm or so.

I cant use ACC since this board is with SB600.

I suspected the memory system however that wouldnt make sense since Ive ran Memtest already. Not very long, but if there would have been serious damage you would find out very soon when starting Memtest.

Ill do a fresh Vista install without anything else, just OCCT and Memtest. What exactly do you mean with 'changed to single core instead of auto'?

lower your vdimm and only apply if needed. that could surely be contributing to the issues (it does for me). vcore too (not as much since your on water, but some chips get unstable with more then needed voltage).