Foxconn BloodRage Issues / BIOS Bugs Thread

[RayderR6]

Hello RayderR6 and OverClocker_gr
This one seems ODD but do u both Set:

Over Integrated Peripherals > OnChip IDE Device

SATA Mode = RAID
OnBoard IDE and eSata Chip = AHCI + IDE Mode

If not, do it and check too uor Removable/CD-ROM Boot Device Priority on Advanced BIOS Features.

Best regards

Hello xX1AinXx, I'm using G13 today.

UPDATE and Edited Original POST: I can confirm on my system if I set the Jmicron IDE and eSata to RAID+IDE or AHCI+IDE, the following errors occur (these do not happen if set to IDE or Disabled).

1) During post there will be 2 repeat lines which are a brighter white and sit on top of normal post text stating "WARNING: Have Option ROM can not be invoke (Vendor ID: 197Bh, Device ID: 2363h)"

2) When I get to the point of a Vista installation where you select the HDD to install on, the following 2 errors occur and it doesn't matter if it's raid volume or ssd or even if the ssd is hooked up (i.e. raid volume platters only):
A) "Windows is unable to find a system volume that meets its criteria for installation."
B) "This computers hardware may not support booting to this disk. Ensure that the disks controller is enabled in the computers BIOS menu."

It has occured to me that Jmicron drivers need to be installed, but I'm not sure as I did not try (ICH10R x64 drivers didn't make a difference). If the Jmicron drivers needed to be installed then this isn't the way I want to go anyway.

With the Jmicron in IDE or Disabled, my ICH10R volumes worked just fine after Vista was loaded anyway, so I didn't spend anymore time with this.